We serve homes across NW London after checking the postcode and the job.
See the Areas page
.
Functional testing is part of a sensible outdoor-lighting visit. It checks that the finished point works
from the switch or control, that aiming and sensor behaviour make sense where the fitting allows, and that
any limitation is explained before handover.
What usually gets checked
Confirm the light operates from the switch, spur, PIR, photocell or control arrangement that applies
to the job.
Check the useful light lands where expected, without obvious glare or wasted spill.
Set or sense-check PIR timing, sensitivity and dusk behaviour where the fitting allows.
Explain any manual override, reset behaviour or product limitation in plain English before handover.
What can change the scope
Hidden damage, water ingress, poor previous work or access constraints can turn a test-and-adjust
visit into repair or replacement work.
Some checks can only be fully judged in the right light conditions, so the final outcome still depends
on what is confirmed on site.
